Industrial Cameras, Industrial Imaging and Machine Vision - Wholesale Distributor - Aegis Electronic Group
Pleora vDisplay HDI-Pro (930-1001) External Frame Grabber
Pleora’s vDisplay™ HDI-Pro External Frame Grabbers transfer video data from network links directly to off-the-shelf or custom video monitors supporting an HDMI connection.
Pleora’s vDisplay™ HDI-Pro External Frame Grabbers allow system manufacturers and integrators to increase system reliability and lower power consumption by eliminating PCs at display monitors. These external frame grabbers are compact, solid-state replacements for PCs where size, weight, power, or reliability are critical considerations. The vDisplay HDI-Pro consumes approximately 3.2 Watts (W), which dramatically reduces electricity costs in 24/7 applications. A start-up time of only a few seconds provides an additional advantage over using a PC with a standard operating system.
vDisplay HDI-Pro External Frame Grabbers interact seamlessly with Pleora's other products in networked digital video systems. The frame grabbers are also compatible with the GigE Vision® and GenICam™ standards, enabling them to interoperate with third-party equipment in multi-vendor systems. The HDI-Pro receives video data from GigE Vision® compliant cameras and outputs it in real time with low, consistent latency over an HDMI/DVI interface.
Features:
- Solid-state device for display of video from GigE Vision-compliant cameras over an HDMI or DVI interface, with low, consistent latency
- Auto-senses monitor resolution and refresh rate capabilities
- Autonomously controls GigE Vision-compliant cameras without the requirement for a software control application
Applications:
- Machine Vision
- Factory Automation
- Robotic Inspection
|
Key Functionality |
•Highly reliable, 1 Gb/s data reception rate with low latency |
|
Camera Type Support |
•Area scan and linescan |
|
Monitor Support |
•Interoperates with VESA compliant single link monitors •Auto-senses monitor display capabilities •Can interoperate with custom displays by manually configuring display timing parameters |
|
Power |
•12-pin Hirose (HR10A-10R-12PB) |
|
Network |
•RJ-45 |
|
Video output |
•HDMI/DVI |
|
Setup and advanced configuration |
•Via eBUS™ SDK or any GenICam compliant application •Settings can be stored in persistent memory •Plug-and-play autonomous control of GigE Vision compliant camera |
|
GigE-Based |
•10/100/1000 Mb/s •IEEE 802.3 (Ethernet), IPv4, IGMPv2, UDP, ICMP (ping), DHCP, and jumbo packets •Long reach: 100 m point-to-point, further with Ethernet switches or fiber |
|
GigE Vision Protocol |
•GigE Vision Streaming Protocol (GVSP) •GigE Vision Control Protocol (GVCP) |
|
Size (L x W x H) |
•Enclosed unit: 81 mm X 59 mm X 40 mm •OEM board set: 81 mm X 51 mm X 26 mm |
|
Operating temperature |
•Enclosed unit: 0°C to 55°C •OEM board set: 0°C to 44°C |
|
Storage temperature |
•-40°C to 85°C |
|
Power Supply |
•5 V to 16 V |
|
Power Consumption |
•3 W to 4.3 W (temperature and input voltage dependent) |
|
ORDERING INFORMATION |
|
|
930-1001 |
•vDisplay HDI-Pro External Frame Grabber enclosed product |
|
930-1002 |
•vDisplay HDI-Pro External Frame Grabber Evaluation Kit, containing 930-1001 and power supply |
vDisplay Autonomous Source Control Configuration
An introduction to multicasting using Pleora's GigE Vision compliant external frame grabbers.