The PoCL version is connected by a single (PoCL) Mini Camera Link cable directly to a frame grabber supporting PoCL. Simple systems construction is possible.
Imager | 1/3-inch interline CCD | |||||
Total pixels | 692 (H) x 504(V) | |||||
Effective pixels | 659 (H) x 494(V) | |||||
Active pixels | 659 (H) x 494(V) | |||||
Pixel size | 7.4 (H) x 7.4 (V) µm (square lattice) | |||||
Sensing area | 4.88 (H) x 3.66 (V) mm | |||||
Scanning system | Progressive | |||||
Aspect ratio | 4:3 | |||||
Frame rate | 120 frames/second | |||||
Horizontal drive frequency | 49.090902 MHz | |||||
Scanning frequency | Horizontal: 62.94 kHz Vertical: 119.88 Hz |
|||||
Sync system | Internal | |||||
Lens mount | C mount | |||||
Video output | Digital output Camera Link Clk = 24.5454 MHz x 2TAP |
|||||
Resolution | Horizontal: 500 TV line Vertical: 490 TV lines |
|||||
Sensitivity | 400 lx, F4, 3200 K | |||||
Minimum illumination | 7.4 lx, F1.4, MAX GAIN | |||||
Signal noise to ratio | 50 dB | |||||
Electronic shutter speed | 1/120 to 1/100000 second (variable setting) | |||||
Gamma compensation | y = 1 | |||||
Frame on demand | Fixed shutter, one trigger and VD reset (Factory setting is all off) | |||||
Partial scan | Selectable start position and width of picture grabbing in 1H step. | |||||
Offset | 0 to 128 steps level/10bit 33 steps variable (Factory setting: 0 steps level) | |||||
Gain setting | 0 to +12 dB (128 steps variable) | |||||
Ambient temperature | Operating: 0 to + 40°C (+32 to +104ºF), less than 90 % RH Storage: -10 to + 50°C (+14 to +122ºF), less than 70 % RH |
|||||
Power supply | 12 ±1 VDC | |||||
Current consumption | Approx. 160 mA (Approx. 2.0 W) | |||||
External dimensions | 29 (W) x 29 (H) x 29 (D) mm | |||||
Mass | Approx. 50 g |